i'v read a few post's about removing the valve just to tidy up the bay, mine was leaking when i did a pressure test so it had to go

this is the purge valve T piece.


and this is when i removed it an tidied it up.

 

Any write ups? How was this done? I'm curious

 

i removed the T piece and basically blanked off the vac line to the manifold and the one to the air intake and then joined the two smaller hoses together with a longer piece of hose,
but i have read the other 2 smaller hoses can be left to vent to atmosphere.

make sure you leave the valve where the electrical connector is connected to plugged in as it may throw a ECL if removed an unplugged.

hope this helps

 

I've binned the lot, along with the tank vent lines and the charcoal canister

 

found this thread its exactly what i need to do so i can run my breatherless intake pipe. can someone please confirm this is the correct way to do it short o doing a total carbon canister removal

 

which ones correct the video show the intake manifold being blanked off but the thread above the guy has linked the intake manifold back to the pipe off the solenoid