Ej20 refit
23 April 2013, 03:29 PM
#1
Scooby Regular
Thread Starter
Join Date: Mar 2013
Location: Burnley
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Ej20 refit
Hi chaps I'm struggling to get my engine back on my gearbox it's an ej20 Iv jacked the gearbox and got it on the 2 bottom studs I just can't get it on the final 2 inch what am I missing ? Cheers matt
23 April 2013, 03:39 PM
#5
I was having had the same with mine a couple of weeks ago.
Give the crank a turn whilst you push the engine against the gearbox and also make sure that the gearbox is well supported (with a jack underneath) otherwise the gearbox just moves about on the hangers when you put force against it.
If that fails check your clutch is aligned and put some grease on the dowels on the bell-housing.
It should drop in quite easily when everything is lined up...
Good luck
Ben
Give the crank a turn whilst you push the engine against the gearbox and also make sure that the gearbox is well supported (with a jack underneath) otherwise the gearbox just moves about on the hangers when you put force against it.
If that fails check your clutch is aligned and put some grease on the dowels on the bell-housing.
It should drop in quite easily when everything is lined up...
Good luck
Ben
Thread
Thread Starter
Forum
Replies
Last Post
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM
