Hub bolt removal
Hub bolt removal
I have to replace all my stud bolts to longer ones, Any advice on removing them please 1996 wrx.
Last edited by howes124; Mar 30, 2013 at 09:30 PM.
Not done them on a scooby before, but usullay just use a big hammer to whack em out.
To fit the new ones line up the splines where they go into the hub and use a load of m12 washers to pack along the stud then use an old wheel nut to tighten up against them and pull the stud in flush to the hub.
To fit the new ones line up the splines where they go into the hub and use a load of m12 washers to pack along the stud then use an old wheel nut to tighten up against them and pull the stud in flush to the hub.
Thread
Thread Starter
Forum
Replies
Last Post