changed cone filter now wont run!!!
#1
Scooby Newbie
Thread Starter
Join Date: Feb 2013
Location: rossendale
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
changed cone filter now wont run!!!
hello i changed the air filter on my 2003 wrx impreza and now the car wont run
i was a little hasty when trying to remove the old filter when i come to starting the engine again the car tried to idle but it just keeps cutting out and wont rev? is it possible i have damaged anythiing when trying to uninstall the old filter i wish i would have left the old filter on now has anyone ever had this prob?
i was a little hasty when trying to remove the old filter when i come to starting the engine again the car tried to idle but it just keeps cutting out and wont rev? is it possible i have damaged anythiing when trying to uninstall the old filter i wish i would have left the old filter on now has anyone ever had this prob?
#2
Scooby Regular
iTrader: (6)
Join Date: Feb 2010
Location: north of the south border
Posts: 4,510
Likes: 0
Received 0 Likes
on
0 Posts
hello i changed the air filter on my 2003 wrx impreza and now the car wont run
i was a little hasty when trying to remove the old filter when i come to starting the engine again the car tried to idle but it just keeps cutting out and wont rev? is it possible i have damaged anythiing when trying to uninstall the old filter i wish i would have left the old filter on now has anyone ever had this prob?
i was a little hasty when trying to remove the old filter when i come to starting the engine again the car tried to idle but it just keeps cutting out and wont rev? is it possible i have damaged anythiing when trying to uninstall the old filter i wish i would have left the old filter on now has anyone ever had this prob?
Have you swapped the maff housing as this can alter the readings the maff gives and will cause these types of issues.
#6
Scooby Newbie
Thread Starter
Join Date: Feb 2013
Location: rossendale
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
#7
Scooby Newbie
Thread Starter
Join Date: Feb 2013
Location: rossendale
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#9
Scooby Regular
iTrader: (1)
Join Date: Jan 2012
Location: anglesey
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
Out of curiosity, have u pushed the new filter onto the pipe too much? If this is the case you are starving the engine of air and therefore it wont run and youll have the symptoms described. best to take filter off but leave maf connected to see if itl run, if not its the maf.
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
oilman
Trader Announcements
15
01 October 2015 11:55 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM