fuel pipe layout which go wear help please
#1
Scooby Regular
Thread Starter
fuel pipe layout which go wear help please
Hi all just need some help on how to connect up all my fuel pipes I have a 1993 wrx ra I've put a new engine in but the previous owner removed the engine and I'm not sure how all the fuel pipes connect up at the moment I have the rails fitted under the manifolds and that's it no fuel pipe to any of the connections a diagram or any help would be great also the injector nearest the brake servo has a right angle elbow in the rail is this for the fuel pressure regulator thankyou for Any help you can give me
Last edited by narelle; 10 February 2013 at 06:51 PM.
#3
Scooby Regular
Join Date: Dec 2012
Location: England
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
If it's just a right angle elbow with no regulator fitted (is there a vacuum line connection on there) then that means someone has previously fitted a separate regulator. So you'll need to do the same or fit an oem regulator in place of the elbow. I'll check the pipe orientation on the 3 metal pipes going out of the inlet manifold passengers side. bottom is the thin one going to fuel tank breather. Middle is the return and top goes to fuel filter supply.
#5
#6
Scooby Regular
Thread Starter
It's definitely an after market fp regulator I have it just need some help plumbing the fuel pipes up I have a right angle elbow on the injector next to the brake servo think this is for the fp regulator and next to this I have two more pipes one big one small think this is a breather were does the big one go then same again on same side of engine at the front were does the big pipe go from there will get pics up asAP thanks for your help already
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
hedgecutter
General Technical
3
25 September 2015 02:35 PM