How to make phase 1 fuel rail fit phase 1.5 inlet??
18 December 2012, 01:06 PM
#1
How to make phase 1 fuel rail fit phase 1.5 inlet??
Basically I've gone to fit my parallel fuel setup but because I've changed to a v3/4 inlet the holes that you use to bolt the rails to the inlet don't line up. Is there a way of getting round this? I have seen this: http://www.ebay.co.uk/itm/subaru-imp...vip=true&rt=nc
Looks like exactly what I need, phase 1 rails fitted to 1.5 inlet but how was it done?
Looks like exactly what I need, phase 1 rails fitted to 1.5 inlet but how was it done?
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
BHPvstorque
Subaru Parts
1
13 September 2015 06:42 PM
