Oil change and filter
#2
Scooby Regular
Join Date: Oct 2012
Location: gloucester
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
#5
After replacing filter and oil and before starting engine.
Remove crank shaft sensor plug, so that engine will not fire.
Then crank engine over until oil light goes out, can take quite a while.
Then replace crank shaft sensor plug and start engine, check for any leaks.
Remove crank shaft sensor plug, so that engine will not fire.
Then crank engine over until oil light goes out, can take quite a while.
Then replace crank shaft sensor plug and start engine, check for any leaks.
#6
Scooby Regular
iTrader: (34)
fill filter to the brim and let it soak in for a while and repeat until takes no more then a smere round the seal so you get a good seal when re-fitting, have never removed crankshaft sensor myself and never had any issues but i am not saying dont do it, this has been covered countless times in great length, if you do a search
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post