Blobeye STi turbo oil feed pipe
#1
Blobeye STi turbo oil feed pipe
Having to replace mine as it has a crack in it.. so do you use any sealant male to female connector when replacing the pipe? PTFE tape? Threadlock? Or just screw it on? I'd presume you need to use something.
Obviously the feed on the turbo uses gaskets, but there seems to be nothing for this bit?
Thanks
Obviously the feed on the turbo uses gaskets, but there seems to be nothing for this bit?
Thanks
#2
Scooby Regular
Join Date: May 2008
Location: Warrington
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
If you are using the standard pipes then you should only need to use the copper crush washers on the banjo bolts, the other joints should have a conical shape which should seal upon tightening.
Where did you get replacement pipes from though? I had to have some made by a local hydraulics company.
Where did you get replacement pipes from though? I had to have some made by a local hydraulics company.