Hi guys,
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2008
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Hi guys,
HI guys,
I am having a little problem with my v4 sti.
The water pipe going onto the turbo had a split in it, I replaced it.
I added coolant, now the car wont start, it is turning over, but not starting,
Ecu is reading code 21, which is coolant sensor,
Could this cause the problem?
I also took out the crankshaft sensor and cleaned it then put it back in.
any ideas?
thanks alots,
also the fuel pump seems to be working fine,
I am having a little problem with my v4 sti.
The water pipe going onto the turbo had a split in it, I replaced it.
I added coolant, now the car wont start, it is turning over, but not starting,
Ecu is reading code 21, which is coolant sensor,
Could this cause the problem?
I also took out the crankshaft sensor and cleaned it then put it back in.
any ideas?
thanks alots,
also the fuel pump seems to be working fine,
#3
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2008
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
I didnt remove any sensor, just remove the intake/maf etc which i did plug back in,
i just replaced the water pipe, its the pipe that goes on the turbo, rubber one, the car did start then died 5 mins after. then it wont start again, it turns but doesnt start.
i just replaced the water pipe, its the pipe that goes on the turbo, rubber one, the car did start then died 5 mins after. then it wont start again, it turns but doesnt start.
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM