BaojeeX

Hi guys, I've had my blob eye for over a month now and it has unequal headers/cobra decat system. Now, the CEL light doesn't show up on the dash even on ignition, I looked behind the dash but couldn't see a bulb and was told it is a led? Anyway, I used a OBDII scanner today and got these two following codes. The CEL was also show on in the OBDII software.

P0032 - Oxygen Sensor Heater Control Circuit High (Bank 1 Sensor 1)
P0037 - Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2)

I reset the the codes however code P0037 came back.

What are my options? Have the sensors failed due to the decat? Car doesn't run too bad, Get 85miles to 15.65/litres. Working out average mpg is around 28mpg.

JDM_Stig

iTrader: (3)

have you had the mapped for the decat ?

BaojeeX

Well I haven't and don't think the previous owner had.