Mating EJ205 Heads With EJ20G Block Opinions Please
#1
Scooby Regular
Thread Starter
Join Date: Mar 2012
Location: Lancashire
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Mating EJ205 Heads With EJ20G Block Opinions Please
Hi All..
I have Gone down the route of Fully Re-Building A EJ20G Short Motor To Fit My Original EJ205 Heads In Order To Keep All Phase 2 Manifolds Ect..
I am Pretty Sure that I need to Use The EJ20G 1.6mm Gaskets due to the 20G Pistons Rise above the block when on TDC And fitting the Thinner 205 0.6mm Gaskets would cause the piston to Strike the head..
Has anyone Done this sort of rebuild and if so what thickness would you go for?
Many thanks...lee
I have Gone down the route of Fully Re-Building A EJ20G Short Motor To Fit My Original EJ205 Heads In Order To Keep All Phase 2 Manifolds Ect..
I am Pretty Sure that I need to Use The EJ20G 1.6mm Gaskets due to the 20G Pistons Rise above the block when on TDC And fitting the Thinner 205 0.6mm Gaskets would cause the piston to Strike the head..
Has anyone Done this sort of rebuild and if so what thickness would you go for?
Many thanks...lee
Thread
Thread Starter
Forum
Replies
Last Post