Turbo Elbow too short
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2005
Posts: 505
Likes: 0
Received 0 Likes
on
0 Posts
Turbo Elbow too short
Just looking at putting a 2005 STI intercooler on a 2006 WRX. I've heard there might be an issue with the brackets and /or the rubber turbo hose elbow on the ypipe being about an inch too short. I believe it's because the turbo on the sti has a longer output pipe??
Cheers,
Andy
Cheers,
Andy
#2
Twatful
Join Date: Apr 2003
Location: Grew up and don't drive Scoobs anymore!
Posts: 9,050
Likes: 0
Received 0 Likes
on
0 Posts
Brackets will be fine as the mounting points already exist within the WRX, just take off the brackets and move them to the outer mounting points.
For hoses, when I did mine I bought a Samco set of turbo pipes and used this on the alloy Y piece with no problems, actually thinking about this I think I trimmed a little off the Samco's but found that this was not needed.
Can't quite remember as it was so long ago!
For hoses, when I did mine I bought a Samco set of turbo pipes and used this on the alloy Y piece with no problems, actually thinking about this I think I trimmed a little off the Samco's but found that this was not needed.
Can't quite remember as it was so long ago!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
jobegold@hotmail.co.uk
ScoobyNet General
2
27 September 2015 09:44 PM