Is it adviseable to fit a 3" downpipe to a 2.5" centre and rear?
#1
Scooby Regular
Thread Starter
Join Date: Sep 2006
Location: Salisbury in Wiltshire
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Is it adviseable to fit a 3" downpipe to a 2.5" centre and rear?
Ive just bought a seconds hand exhaust system under the impression that it was a 3" system but its not.
Its 3" downpipe with a flat end to centre section
A 2.5" centre, with a floating mating face and a tapered flange and the front that does not look like its going to fit the downpipe at all but the chap i bought it from says he had it fitted to his 2000W turbo fine.
Any ideas?
Its 3" downpipe with a flat end to centre section
A 2.5" centre, with a floating mating face and a tapered flange and the front that does not look like its going to fit the downpipe at all but the chap i bought it from says he had it fitted to his 2000W turbo fine.
Any ideas?
#6
Scooby Regular
Join Date: Dec 2011
Location: Ayrshire
Posts: 435
Likes: 0
Received 0 Likes
on
0 Posts
I had the same on my blobeye, 3" snakehead downpipe and the rest 2.5", just make sure its getting remapped if your fitting anything smaller than what its mapped for.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM