Head Gasket replacement, Rod/Main Bearings?
#1
Scooby Newbie
Thread Starter
Join Date: Mar 2012
Location: Cheshire
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Head Gasket replacement, Rod/Main Bearings?
Hello, I currently have an early (97) EJ20 engine out with the heads off.
The bottom end moves freely and had no apparent problems when running but @ 60k and being an import, I am wondering if maybe I should go further and strip the bottom end and fit ACL Race bearings?
I see plenty of these cars suffering from a spun bearing and was just wondering if it would make sense to replace, or leave alone?
The bottom end moves freely and had no apparent problems when running but @ 60k and being an import, I am wondering if maybe I should go further and strip the bottom end and fit ACL Race bearings?
I see plenty of these cars suffering from a spun bearing and was just wondering if it would make sense to replace, or leave alone?
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM
bearing, bottom, end, engine, failure, gasket, head, headgasket, repalacment, replacement, rod, spun, subaru, treatment