Power FC removal on MY97 UK
20 March 2012, 09:55 PM
#1
Scooby Regular
Thread Starter
Join Date: Dec 2005
Location: York
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Power FC removal on MY97 UK
Hi all its been a while...
Removed the Power FC from my MY97 UK car as im returning it back to standard.
I have swapped the wiring back over between the cam & crank sensor(at the ECU)
Is there anything else i need to change? just switched the ignition on after fitting the old ecu and can hear what i believe is the fuel pump relay click but cant hear the pump prime. It was a few years ago when the power FC was fitted so cant quite remember if there were any other wiring changes.
Removed the Power FC from my MY97 UK car as im returning it back to standard.
I have swapped the wiring back over between the cam & crank sensor(at the ECU)
Is there anything else i need to change? just switched the ignition on after fitting the old ecu and can hear what i believe is the fuel pump relay click but cant hear the pump prime. It was a few years ago when the power FC was fitted so cant quite remember if there were any other wiring changes.
20 March 2012, 10:28 PM
#2
Scooby Regular
Join Date: Feb 2002
Location: Earth
Posts: 879
Likes: 0
Received 0 Likes
on
0 Posts
Fuel pump relay is B137 pin 17 on a UK car
Fuel pump relay is B137 pin 7 on a JDM car (and I assume power fc)
You will also be adding the immobiliser back in by putting the stock ECU back, so make sure it is the original ECU and original keys.
Fuel pump relay is B137 pin 7 on a JDM car (and I assume power fc)
You will also be adding the immobiliser back in by putting the stock ECU back, so make sure it is the original ECU and original keys.
Thread
Thread Starter
Forum
Replies
Last Post