Firez34

iTrader: (5)

Guy's are there any how to's or guides on how to do this. I've noticed my original rail pipes are corroding quite bad in places. So I've looked at a few kits @ around £180. Times are hard at the mo and I was wondering if any of you have DIY'd it. What would I need to buy in terms of fittings, pipe and Reg if it can be done and where could I order the parts from. There also appears to be 2 other lines down in there attatched to the rail as well One to the intake manifold and one to a canister near the front of the engine bay. Do these need re piping
Any pic's, advice or a walkthrough for how you've DIY'd it more than welcome, thanks Steve.

Found what I needed here:

http://www.type-ra.co.uk/vB/showthread.php?t=4893

Firez34

iTrader: (5)

Anyone help with this, bump.