stevemoir

iTrader: (24)

Hey folks I'm looking to install an afr gauge I already have the wideband installed through my Syvecs

Does anyone know how to install a gauge even though the wideband is already there

Cheers

Steve

jura11

iTrader: (7)

Hi Steve

I'm running AEM Uego gauge which is like you are want AFR gauge and its fitted after turbo and fitting not sure,everything fitted Neil@Slowboy racing

I'm running too Syvecs,but wideband will be fitted in soon and we are looking fit this wideband in to the center pipe

Jura

stevemoir

iTrader: (24)

Hi mate the wideband is already installed but I'm hoping the gauge is just plug and play and no splicing involved

Steve

jura11

iTrader: (7)

Not sure about this Steve,probably worth have post question on the Syvecs forum

How to say,we are running at moment just AEM UEGO O2 Wideband and no wideband which is connected into the Syvecs,but if we want run wideband via Syvecs we will must run this via extra lambda sensor which will be at centre pipe or downpipe,not sure about the splicing(but i wouldn't go via this way)

Technically you can go via like we are done via AEM UEGO O2 wideband


Jura

JTinnovations

iTrader: (2)

You can't "splice" one lambda to feed two different things. If you have an aftermarket wideband gauge you can sometimes take a voltage out of it's controller, which you can then feed to the Syvecs instead of wiring a wideband to the Syvecs. I believe you can do this with the Innovate stuff, not sure about AEM.

If you already have a wideband wired to the Syvecs, then you could consider a Toucan touchscreen display - this has a lambda gauge incorporated