scoobydan1985

i just got a new engine but it came out of a classic finally got it running after
hello need a little help on my 2002 bugeye

swapping and changing parts from my last engine

but now i have it started when it comes to boost its laggy and got no go and very noisy like its chocking up and when its idle its very lumpy

i done a diagnostic check and it says

camshaft position sensor malfunction

and heated oxygen

i have checked all breathers over and over and checked everything i am now out of ideas

all help is appreciated
cheers dan

scoobydan1985

also sorry changed the cam sensor 3 times

GpMarty

iTrader: (7)

have you put your cam pick up wheel and your crankshaft sprocket on it off the 2002 it needs these on a classic engine to run on a 2002?

scoobydan1985

I have put the sprocket on not the cam wheel will that cause that
Cheers Danny

scoobydan1985

Would that wheel also cause the turbo to lag as its trying to boost

P1Drifter

iTrader: (7)

check the cam timing as well