Peeps, i changed my clutch yesterday (ball ache!) and although it runs fine i have c.e.l on the dash which shows code P1092 but i cant cross referance that with my manual as it doesnt show this code.Im sure ive seen this code on here before but couldnt find it in a search!!!

im thinking either rear o2 sensor (i may have forgotten to connect it but havnt been able to get to car to check!!)or tumble sensor on the inlet manifold as i broke this when my breaker bar slipped (D'OH)although i did do a good job of repairing it and its still in place.
what does the tumble sensor/motor do anyway??

i have started the car up to 10 times since the light came on but it still shows.all help much appreciated

bugeye 2001 wrx with minor mods.

 

P1092 Tumble Generated Valve System 2 (Valve Open)

 

Aha! ive just read a post on NASIOC and it seems the code relates to the tgv.on this thread it describes doing the tgv delete but more interestingly it showed a rubber pipe coming off the valve body.I found a small pipe just like that on the undertray and thought it was something else!!!!!!it must've come off when i smacked into the valve!where does this pipe go once attached to the vave itself???????

 

Nice one Bodski.

If i was to obtain another tgv would it be as simple as unbolting and bolting on??and would the cel self extinguish??

 

No expert, but I'd of thought so. CEL should reset after 6 restarts of the engine.