Hi everyone
My first post hope it's in right place . So I bought a 01 bugeye wrx couple months back. at first lovely car no trouble then clutch slips so had new clutch put in.next day engine light on back to garage lambda sensor no good so that's replaced.drive home fine.next day hesitation on acceleration in 4th an engine light flashes for about 10 secs then goes out got back home checked an tightened all air hoses an clamps. Went back out no hesitation but when pulling in 4th engine light flashes then goes out . Back to garage next day to pull codes NO codes not even historic???
Any suggestions appreciate any help. Sorry for essay

Wolfy

 

A Common problem with all bugeyes im afraid. The light you are referring to is the CEL light. The most common fixed for this are to check if all of the plugs are gapped properly (as a misfire on any cylinder will show the CEL light) of if you have a faulty Neutral position switch.

Hope this helps

 

Thanks mate will check it out

 

Bloody typical my CEL light came back on today after months of it being OK. On the motorway, needed to pass a car a bit sharpish, dropped from 5th to 4th at about 50 mph and the light came back on..... a trip to Indigo to run diagnostics on it i think.

Shaun

 

Hi all
Any one used POWERSTATION .good /bad ???
Cheers wolfy

 

If you do a search on here you will find a Thumbs up for powerstation.

 

Will ave a look thanks . This site slow today lol

 

where are you based

 

Cheltenham mate