hi lads, just wanted a bit of advice on a kit i bought from someone to make a set of 440 phase 2 inj. fit my v1. rails. just dont know if its the right kit. this is what i got :
the pic shows a red inj instead of the yellow 440? :
these are my inj. :
and with collars on :
and :


does it look like they are sitting correctly? im just not sure. any help much appreciated. ps sorry the pics are so big lol.

 

anyone?

 

Anyone help me with this cheers.

 

still no one can help with this??

 

Wouldn't worry about the different coloured injector, the instructions there clearly say V5/6 injector into v 1-4 fuel rails so that sounds right! Couldn't comment on the kit though but I'll be looking to do the same myself when I get my scoob remapped!

 

you will need to put the large Oring on the collet then they are done

 

O ring on to the collar, fit in to rail, use bolts with spacers in between cap s & rails, tighten, job done!

 

thanks very much lads. cheers for the info, looking to get mapped in a month or so and wanted to make sure this was gonna fit. would a mapper fit these on the day or will i have to arrange to get this done? im in scotland so will be getting andy forrest for the mapping.

 

You could do it yourself in an hour matey just drive off boost until its mapped

 

thanks bud so ill not damage the engine if i fit them and drive gently?. i might just let the guys at RA motorsport fit them as they have andy through once a month for sessions and it will be getting done there. thanks again m8.