Fitting Revolution exhaust to 2.5" downpipe
#1
Scooby Regular
Thread Starter
Join Date: Feb 2005
Location: Lincoln
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Fitting Revolution exhaust to 2.5" downpipe
I have just bought the Revolution catback from the Bay and understand it should fit straight onto a 2.5" downpipe, however the flange on the centre pipe is 3". Will this still fit ok against the smaller diameter downpipe or will I need an adaptor?
Also, what wire gasket will I need and where is the best place to get one from as my local fitter would get them from the dealers and I don't know if the one for the standard exhaust will fit.....
Desperate to get it fitted now!
Also, what wire gasket will I need and where is the best place to get one from as my local fitter would get them from the dealers and I don't know if the one for the standard exhaust will fit.....
Desperate to get it fitted now!
#3
Scooby Regular
Thread Starter
Join Date: Feb 2005
Location: Lincoln
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Yeah you're correct about the slip joints, it's just that the bore of the adaptor measures 3" so I wondered if it would meet the 2.5" downpipe ok?
#4
Scooby Regular
Thread Starter
Join Date: Feb 2005
Location: Lincoln
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Anyway, got this fitted yesterday, went straight on to the 2.5" downpipe so all good and much quieter. :-)
Just got to get rid of the Nur Spec now......
Just got to get rid of the Nur Spec now......
Thread
Thread Starter
Forum
Replies
Last Post
KOEScoob
ScoobyNet General
6
17 September 2015 03:51 PM