Help with fitting a walbro fuel pump on my jap classic
#1
Scooby Regular
Thread Starter
Join Date: Apr 2010
Location: ednburgh
Posts: 441
Likes: 0
Received 0 Likes
on
0 Posts
Help with fitting a walbro fuel pump on my jap classic
Just wondered if there was a guide on fitting a walbro fuel pump on my 95 classic wrx import, how difficult is it?
#2
Unmapped 12.4s @ 105
iTrader: (29)
Join Date: Apr 2005
Location: Newcastle. 330bhp-289lb/ft @ 1bar boost - 12.4s @ 105mph
Posts: 11,776
Likes: 0
Received 4 Likes
on
4 Posts
It's easy, hardest part in my opinion is getting the pipes of the top of the sender/carrier unit.
Back seats out, remove cover plate on the drivers side.
That gives you access the sender unit. Remove fuel lines, nuts and wiring plug and carefully remove. Remember where the fuel lines go though.
Swap the pump over and replace, might be wise to get a replacement gasket though as they can perish.
Only got two pics on photobucket;
Back seats out, remove cover plate on the drivers side.
That gives you access the sender unit. Remove fuel lines, nuts and wiring plug and carefully remove. Remember where the fuel lines go though.
Swap the pump over and replace, might be wise to get a replacement gasket though as they can perish.
Only got two pics on photobucket;
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
DogsofWar
Engine Management and ECU Remapping
16
23 September 2015 07:41 PM