Fault code 32
#1
Fault code 32
Ok I reset the ecu this afternoon after removing/refitting the maf.
When I did a diagnostic check the engine light picked up fault code 32 which appears to be the O2 sensor?please correct me if I'm wrong.
Am I ok to use the car until after the weekend?I can't get it looked at until Tuesday.
Also,is it the sensor after the turbo on the down pipe?
Any ideas on prices and where to get it from?
My car is a 99 version 5 type R sti.
Thanks.
Danny.
When I did a diagnostic check the engine light picked up fault code 32 which appears to be the O2 sensor?please correct me if I'm wrong.
Am I ok to use the car until after the weekend?I can't get it looked at until Tuesday.
Also,is it the sensor after the turbo on the down pipe?
Any ideas on prices and where to get it from?
My car is a 99 version 5 type R sti.
Thanks.
Danny.
#2
Scooby Regular
iTrader: (10)
You can use the car as per normal ,it will just run a little rich,it is located just after the turbo and connected via a white plug.New ones can be quite expensive ,but do a search on here for the best prices.You can get a 2nd hand one ,but no guarantee how long it will last for ,bosch ones tend to start at about £100+
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM