HI peeps
Which hole does japspeeds FMIC pipework pass through in the inner wing.
The front or the rear one.
I mean the two holes behind the air box after its removed.
Cheers peeps

 

First one i think,because almost every FMIC use first hole matey.



Jura

 

Cut the steel out between the two holes.

 

This thread title is so wrong ........and misleading

 

Boo I was gonna say brown...

 

It goes through the hole further back.

 

LOL, worked tho!!!!

 

Yeah, best way to get attention

 

So wil I need to cut the piece of metal out between the two holes to enable me to fit a child air induction in the wing and a fmic?

 

It does not really matter. With a small grinder, power hacksaw or jig saw you can make a neat job of making the two holes into one. Paint the edges and apply beading and it will look very professional. If you do not have beading/edge trim you can slit a piece of rubber pipe to perform the same purpose.
If you were really stuck you could even use tin snips until you borrow a power tool to tidy the edges up.

On the Hybrid kit which I sell, and I understand the Japspeed is a copy but only bar and plate, the CAK goes to the front hole and the FMIC behind.
I have CAKs in stock.

 

.............you are going to stick a child in the wing ?

Shaun

PS nice to see you back Harvey

 

Cheers.
It does make the job a lot easier and you want the biggest filter you want in there, ie. biggest surface area for filtration.

 

 

As it happens I have a HDI CAK for sale with MAF tube - all left over from my GTII kit (gone MAF less now!