Rocker gasket question
31 May 2011, 04:22 PM
#1
Scooby Regular
Thread Starter
Join Date: Apr 1999
Location: Surferk
Posts: 2,464
Likes: 0
Received 0 Likes
on
0 Posts
Rocker gasket question
Hello
Daft question but I thought I'd ask...
I have an oil leak from one of the bolts on my rocker cover. Do I just take out the bolt and then remove the gasket without having to take the whole cover off?
thanks
Mark
Daft question but I thought I'd ask...
I have an oil leak from one of the bolts on my rocker cover. Do I just take out the bolt and then remove the gasket without having to take the whole cover off?
thanks
Mark
31 May 2011, 05:31 PM
#3
Scooby Regular
Join Date: Apr 2008
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
Agreed ^^
Additionally don't be tempted to replace some of the gaskets as you will only end up doing it again. You should do the main one, the bolt gaskets and the two spark plud / coil pack gaskets. Also remember to use liberal amounts of a quality gasket sealant.
Additionally don't be tempted to replace some of the gaskets as you will only end up doing it again. You should do the main one, the bolt gaskets and the two spark plud / coil pack gaskets. Also remember to use liberal amounts of a quality gasket sealant.
01 June 2011, 10:11 AM
#5
Scooby Regular
Thread Starter
Join Date: Apr 1999
Location: Surferk
Posts: 2,464
Likes: 0
Received 0 Likes
on
0 Posts
Hello
It's the drivers side at the top. I've had the complete gaskets done about 2 years ago so it "should" be ok. I try just doing the bolt and keep my fingers crossed.
It's the drivers side at the top. I've had the complete gaskets done about 2 years ago so it "should" be ok. I try just doing the bolt and keep my fingers crossed.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM