cost of darton sleeving a 2.5 SCDB
05 February 2011, 11:39 AM
#2
Scooby Regular
Join Date: Nov 2006
Location: Enginetuner.co.uk Plymouth Dyno Dynamics RR Engine machining and building EcuTek SimTek mapping
Posts: 3,662
Likes: 0
Received 0 Likes
on
0 Posts
We still worry about this one. What's your projected power and torque output? Turbo choice?
05 February 2011, 12:26 PM
#3
Scooby Regular
Thread Starter
iTrader: (24)
Join Date: Oct 2009
Location: Aberdeen
Posts: 2,604
Likes: 0
Received 0 Likes
on
0 Posts
hi alan
my current set up is 2003 sti (standard engine)
md321t
tubular headers
850 cc injectors
perrin fmic
avcr
ap racing clutch
my main aim is 450 with similar torque i dont want to much just maybe close to 500 but that would be in the future
cheers
steve
my current set up is 2003 sti (standard engine)
md321t
tubular headers
850 cc injectors
perrin fmic
avcr
ap racing clutch
my main aim is 450 with similar torque i dont want to much just maybe close to 500 but that would be in the future
cheers
steve
05 February 2011, 02:34 PM
#4
Scooby Regular
Join Date: Nov 2006
Location: Enginetuner.co.uk Plymouth Dyno Dynamics RR Engine machining and building EcuTek SimTek mapping
Posts: 3,662
Likes: 0
Received 0 Likes
on
0 Posts
Maybe sleeve if you have no choice, but I hold the view that you may be swopping one worry for another one.
05 February 2011, 03:05 PM
#5
Scooby Regular
Thread Starter
iTrader: (24)
Join Date: Oct 2009
Location: Aberdeen
Posts: 2,604
Likes: 0
Received 0 Likes
on
0 Posts
cheers for the response alan
i see RCM do a 2.5 block with nitred crank for just over 2K
would i need to port my inlet for the use of my 2.5 shortblock
cheers
steve
i see RCM do a 2.5 block with nitred crank for just over 2K
would i need to port my inlet for the use of my 2.5 shortblock
cheers
steve
Thread
Thread Starter
Forum
Replies
Last Post