P1 boost question...
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Oct 2006
Location: Hertfordshire
Posts: 1,083
Likes: 0
Received 0 Likes
on
0 Posts
P1 boost question...
Hi all i'm gunna be back in a scoob after 2morro........... after having a WRX and a Type R which wer both great cars even thou they had there problems lol i'm pickin up a P1 2morro and was wondering what sort of boost presure it should be running as std psi and bar please
#2
Scooby Regular
iTrader: (8)
If my sources and memory are correct:
Peaks vary depending on fuel/ environmental conditions/how hot the turbo is and any intake or exhaust modifications. In this way they also vary from car to car too.
According to Mike Wood from Prodrive, the P1 boost peaks at about 17.5 psi(1.25bar)
It is the held boost the ECU controls and the targets is uses are 15.7 PSI midrange dropping off to 14.6 PSI at the top end. It will never precisely achieve these targets in all gears/conditions/driving situations, but those are the targets in the ECU.
The P1 and STi boost map are both the same, 15.7PSI - dropping to 14.6PSI. These are held boost targets, peaks are higher and variable as said.
Peaks vary depending on fuel/ environmental conditions/how hot the turbo is and any intake or exhaust modifications. In this way they also vary from car to car too.
According to Mike Wood from Prodrive, the P1 boost peaks at about 17.5 psi(1.25bar)
It is the held boost the ECU controls and the targets is uses are 15.7 PSI midrange dropping off to 14.6 PSI at the top end. It will never precisely achieve these targets in all gears/conditions/driving situations, but those are the targets in the ECU.
The P1 and STi boost map are both the same, 15.7PSI - dropping to 14.6PSI. These are held boost targets, peaks are higher and variable as said.
Last edited by Glowplug; 27 November 2010 at 05:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM