Notices
General Technical
Sponsored by:
Sponsored by: CARiD

lumpy idle etc etc

Thread Tools
 
Search this Thread
 
Old Apr 8, 2002 | 01:30 PM
  #1  
davecoombs's Avatar
davecoombs
Thread Starter
Scooby Regular
 
Joined: Oct 2001
Posts: 257
Likes: 0
Post

Hi,
I have a lumpy tickover and sometimes a bit of fluffing when accelarating.
I looked at the breather on the left hand side of the block and there is a bit of oil there. Would a crappy seal cause this ? I used the check engine light to check for sensor faults and there were none.
Where could I get a gasket for the breathere and how much are they ????

Cheers
Reply
Old Apr 8, 2002 | 04:28 PM
  #2  
davecoombs's Avatar
davecoombs
Thread Starter
Scooby Regular
 
Joined: Oct 2001
Posts: 257
Likes: 0
Post

Come on !
Any ideas ??????
Reply
Old Apr 8, 2002 | 11:05 PM
  #3  
Jonesy's Avatar
Jonesy
Scooby Regular
 
Joined: Dec 2000
Posts: 199
Likes: 0
Post

I had the same problem with the lumpy idle, nothing showing up on diagnostics but dealer replaced the oxygen sensor and this seems to have fixed it.
Reply
Old Apr 9, 2002 | 03:25 PM
  #4  
jmca's Avatar
jmca
Scooby Regular
 
Joined: Nov 2001
Posts: 228
Likes: 0
Post


Try the MAF sensor. I have bad idle before & took the sensor out & cleaned it with cotton buds & carb cleaner - very carefully.

This cured it perfectly. The sensor was very dirty but not showing up any error code!

Johny.
Reply
Old Apr 10, 2002 | 08:04 PM
  #5  
john the gasman's Avatar
john the gasman
Scooby Newbie
 
Joined: Apr 2002
Posts: 1
Likes: 0
Lightbulb

Was the lump idle intermittent or continous?.i have same prob and is in next week for service.Been to 2 dealers for same prob but no faults showed on diagnostics.did you have surging whilst accelerating under load? or am i just lucky in having 2 faults!
Reply
Old Apr 12, 2002 | 10:30 AM
  #6  
ROSSC's Avatar
ROSSC
Scooby Regular
 
Joined: Jan 2002
Posts: 230
Likes: 0
Question

Jmca,

Do you know the location of the MAF sensor on a STI v4 ?

Cheers
Reply
Old Apr 12, 2002 | 12:26 PM
  #7  
jmca's Avatar
jmca
Scooby Regular
 
Joined: Nov 2001
Posts: 228
Likes: 0
Post


Rossc,

Should be between the air filter & the turbo intake. I have a MY95 so the sensor is different to yours I think, but the position should generally be the same.

Regards

Johny
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
Nov 3, 2021 11:07 AM
SilverM3
ScoobyNet General
8
Feb 24, 2021 01:03 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
supshon
General Technical
2
Oct 3, 2015 08:06 PM




All times are GMT +1. The time now is 03:00 PM.