Ninja 2 close to bumper
#4
Scooby Regular
Thread Starter
iTrader: (22)
Join Date: Nov 2008
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts
With the hangers, what do you mean? They are welded to the back box?
Sorry if it's clear, been awake for hours and I'm so tired and on an iPod touch
Iggy, where did you get that from?
Sorry if it's clear, been awake for hours and I'm so tired and on an iPod touch
Iggy, where did you get that from?
#7
Scooby Regular
iTrader: (9)
Join Date: Nov 2008
Location: South Wales
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
Very quick delivery & good quality item!
Only a slight mod required to the bumper for a excellent fit
Trending Topics
#9
Scooby Regular
iTrader: (9)
Join Date: Nov 2008
Location: South Wales
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
Took me about an hour to fit
Initially helped with a second pair of hands, as the Carbon Fibre shield didn't fit exactly!
So with it being held securely in place, I managed to establish that the OE bumber had to by modified just a little:
From the top of the exhaust, just to the right on the off-side there is a small bit of green tape.
Here's a closer image;
I had to cut a small triangle out of the OE bumper, which allowed the CF shield to sit better. Below is the setion I had to cut out;
I maybe should have cut the same section from the near side of the OE bumper, to make an absolutely perfect fit! But i'm happy with just the bit that I cut out of the off side of the exhaust arch!
With the section of OE bumper cut out, I could hold it in place and mark out the holes to be drilled in the bumper!
The finished article, where I used allenkey flat-head bolts;
Any questions, give me a shout
Last edited by IggyRB320; 30 October 2010 at 11:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM