Subaru Impreza STI Version 7 JDM AVCS Cylinder Heads
#1
Scooby Regular
Thread Starter
Join Date: Jan 2009
Location: bridgend
Posts: 151
Likes: 0
Received 0 Likes
on
0 Posts
Subaru Impreza STI Version 7 JDM AVCS Cylinder Heads
i going to fit these heads to a cosworth stroker cdb. what else would i need to fit these to a version 2 sti. also who could to the wiring for me plz
#2
Former Sponsor
iTrader: (30)
Join Date: Jan 2005
Location: FB Tuning Workshop - HP27
Posts: 4,219
Likes: 0
Received 0 Likes
on
0 Posts
You'll need to fit a later inlet manifold (99>) or buy some inlet manifold adaptors from Carl Davey and cut'n'shut your existing manifold.
I presume you're running an aftermarket ECU in order to drive thew AVCS solenoids, so fitting the later inlet and anciliaries may be the easiest option, as you should also be able to configure the later TPS, ISCV etc.
IMO, there are better options out there than the Cosworth Stroker Kit, as it uses a standard length rod - Have a chat to Mark @ Lateral
I presume you're running an aftermarket ECU in order to drive thew AVCS solenoids, so fitting the later inlet and anciliaries may be the easiest option, as you should also be able to configure the later TPS, ISCV etc.
IMO, there are better options out there than the Cosworth Stroker Kit, as it uses a standard length rod - Have a chat to Mark @ Lateral
Thread
Thread Starter
Forum
Replies
Last Post
Danny0608
Subaru Parts
0
12 September 2015 02:59 PM