EJ20 to EJ22 swap info req.
23 September 2010, 01:12 PM
#1
Scooby Newbie
Thread Starter
Join Date: Jul 2009
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
EJ20 to EJ22 swap info req.
Right due to a certain ingress of water in to my engine - 2.0l EJ20 (legacy phase 1 1989 - 94?) it requires replacement. I have a option of a 2.2l EJ22 from an early 2000's car. I believe this is a semi open deck block as opposed to the CDB however it will be NA and im not looking for stupid BHP.
Does anyone know if I will be able to use the original ECU from the EJ20 block (with a remap).
Also is the exhaust outlets / Manifold the same so I can use my existing exhaust with minimal modification.
Are there any other major differences that are going to cause me issues? Bare in mind the engine is no longer in a subaru so its just the engine without power steering pumps / AC pump etc.
Any help appreciated. Ta.
Does anyone know if I will be able to use the original ECU from the EJ20 block (with a remap).
Also is the exhaust outlets / Manifold the same so I can use my existing exhaust with minimal modification.
Are there any other major differences that are going to cause me issues? Bare in mind the engine is no longer in a subaru so its just the engine without power steering pumps / AC pump etc.
Any help appreciated. Ta.
Last edited by one_happy_hippy; 23 September 2010 at 01:20 PM.
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM
