palmer4588

hi all i have a 94 type ra and i was wondering how hard it is to fit a turbo up pipe????
thanks rich

FB Tuning

iTrader: (30)

It's not a difficult job - Some/all of the 14mm head M10 nuts and bolts may give you some grief though, as they can get seized due to all the heat they have to endure over time.

Make sure you use a good quality 14mm six sided socket for the job, and one of these may come in handy..

turboaddict

iTrader: (2)

narr its not that hard mate its just a bitch to get too....use plenty of plus gas on them bolts leave for 5 min then crack em off....u might have to jack to engine up a few inch in order to get the old up pipe out.....look on utube there is a cupple of vids on there that may help you before you do it .dont bother with the yankie ones as they always do stuff **** about tit....