hello my name is bill and i am from greece.
i have a big problem and i want your help,because here in greece the knowledge is poor.
i want to make a 2.123 project in my wrx engine.
i found from e-bay a ej257 nitride treated crankshaft who is this:

http://cgi.ebay.com/ebaymotors/New-O...Q5fAccessories

I also am thinking to put MANLEY Hbeam rods(which are better than eaglea)and enough cheap.what do you also think about these???

the big problem is that i can't find cheap wisecos or CPs about that project
what can i do?
do you know any part number that could help me?

i want to put on td05 20g 7cm.what is your opinion?where is the start of spooling in this turbocharger?in 2.0l ?

thank you and sorry for my bad english

 

correct me if i am wrong but aren't the nitrided cranks supposed to be black in colour.?

 

try here fella for info

http://www.andyforrestperformance.co.uk/index2.html

 

anyone else???

 

You will need a stroker kit for the 2.1 as the rods are suppose to be longer for the 2.1.

 

Get insomuch with lateral performance or engine tune. They both offer a strokes kit.

 

http://lateralperformance.co.uk/sect...2d17a4f06a7b65

http://www.enginetuner.co.uk/

http://www.scoobyclinic.com/

 

all companies above can build and send it to you, good luck.

 

Does that Nitrided crank seem VERY cheap too??

 

i don't know.this is the reason for asking you

 

As above you will need a stroker kit which consists of a EJ257 79mm crank, custom length rods and a custom height piston....