ukimpreza

iTrader: (9)

right hopefully found a decent sti v8 block just waiting for bloke to get back to me and ill fetch it if any good. thers a set set of v4 sti heads and cams on the ebay, is there anything else ill require or advised to upgrade? obviously decent cambelt kit gaskets etc. its off into a my96 2000. thanks

scoobymoz

iTrader: (53)

i would use newage JDM STI heads

Midlife......

iTrader: (2)

Then you will need the STi gubbins to run the AVCS !

Shaun

ukimpreza

iTrader: (9)

but not with sti 3/4 heads as thats on v7 heads onwards???? well so i believe

Midlife......

iTrader: (2)

AVCS started on all jap newage cars from the bugeye.... WRX Jap bugeye on the inlet only though.


Shaun

Edited because I thought the OP was putting a Blob STi Block in a UK Bug

ukimpreza

iTrader: (9)

ya dont recommend using the v3/4 heads then?

Midlife......

iTrader: (2)

https://www.scoobynet.com/general-te...ich-heads.html

Have a read here, the heads fit OK but the manifild stud pattern is different for the later versions, As far as I read it the V3/4 heads should mate to your manifold.

Shaun

scoobymoz

iTrader: (53)

That's right I didn't read the post properly i must of still been half asleep

Midlife......

iTrader: (2)

Scoobymoz

I misread the OP too........ I thought There was an STi Block going into a UK Bug WRX.

See edited post 5 .

I must be asleep too LOL

Shaun

scoobymoz

iTrader: (53)

That's what I thought so I just jumped in and posted a reply