up pipe temp sensor
Thread Starter
Scooby Regular
iTrader: (2)
Joined: Oct 2007
Posts: 301
Likes: 0
From: hengoed, south wales
hi guys i replaced the standard up pipe on my bugeye. i ordered a greedy one but by mistake i bought the one without the temp sensor hole in it only to find out when i had it fitted the car has a sensor. the problem i have is my engine management light keeps coming on because it's not connected to the exhaust. i have heard that you can connect a resistor up to stop the temp sensor turning the management light on is this true if so does anybody know how thanks in advance guys.
just put resistor where the plug was removed on the strut tower, but as you are modding a remap will probably follow so can be disabled in the map, think code is P0545 and P0546 to disable the cel light.
Trending Topics
Thanks for that. I have the Prodrive sportcat and second cat delete, only up-pipe left, and I get the P0420 code. Would you expect the car to not drive as well, maybe a little less smooth with this sensor being 'out of range'
Many thanks again! I have been saying this since early 2010, but the remap will remove the CEL once and for all. (cashflow issues have stopped me, although i keep paying out for other little mods!)
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM




