Adjusting the TPS with DCCDpro controller?
#1
Scooby Regular
Thread Starter
Join Date: Jul 2008
Location: Norway
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Adjusting the TPS with DCCDpro controller?
Hi!
I have tried to adjust the TPS to the right value. But I see that it falls around 0,3 - 0,4V when starting the engine. So if I adjust it where it should be with the ignition on, it falls ~0,3V when starting the engine.
I am running a JDM 6MT with the DCCDpro controller, who needs signal from the TPS. Could there be that the extra cable to the controller and the controller itself are "stealing" this voltage when starting the engine?
If so should I adjust the TPS after the voltage when the engine is running then?
Hope you guys have some answers.
Thanks alot!
I have tried to adjust the TPS to the right value. But I see that it falls around 0,3 - 0,4V when starting the engine. So if I adjust it where it should be with the ignition on, it falls ~0,3V when starting the engine.
I am running a JDM 6MT with the DCCDpro controller, who needs signal from the TPS. Could there be that the extra cable to the controller and the controller itself are "stealing" this voltage when starting the engine?
If so should I adjust the TPS after the voltage when the engine is running then?
Hope you guys have some answers.
Thanks alot!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM