How to change temp gauge sender?
29 May 2010, 11:37 AM
#1
Scooby Newbie
Thread Starter
Join Date: May 2010
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
How to change temp gauge sender?
Hi, I've got a 1993 wrx import.
The temperature gauge has stopped working, so I have brought a new sender.
The problem I have is that I have no idea where the sender is positioned, and what i'll need to remove to get to it.
Can anyone help??
Cheers
The temperature gauge has stopped working, so I have brought a new sender.
The problem I have is that I have no idea where the sender is positioned, and what i'll need to remove to get to it.
Can anyone help??
Cheers
29 May 2010, 11:58 AM
#3
Former Sponsor
iTrader: (30)
Join Date: Jan 2005
Location: FB Tuning Workshop - HP27
Posts: 4,219
Likes: 0
Received 0 Likes
on
0 Posts
It's on the back of the water cross pipe, under the inlet manifold.
You'll see 2 seperate sensors - A single pin sender for the gauge on the clocks, and a 2 pin sensor with a brown wiring plug for the ecu.
It's a bit fiddly to change, but can help with access if you take the 90 degree turbo inlet pipe off.
You'll see 2 seperate sensors - A single pin sender for the gauge on the clocks, and a 2 pin sensor with a brown wiring plug for the ecu.
It's a bit fiddly to change, but can help with access if you take the 90 degree turbo inlet pipe off.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM