Unequal & Equal Length Tubular Headers...
#1
Scooby Regular
Thread Starter
iTrader: (22)
Join Date: Jun 2009
Location: North East - Newcastle upon Tyne
Posts: 1,982
Likes: 0
Received 2 Likes
on
2 Posts
Unequal & Equal Length Tubular Headers...
Which are best for performance?
I've got equal length ScoobySport ones at the minute, but i'm missing my 'burble' so guna swap them to unequal tubular/ported ones... I wont be, however, if its going to be detremental (spelling!) to performance.
Cheers, Mark
I've got equal length ScoobySport ones at the minute, but i'm missing my 'burble' so guna swap them to unequal tubular/ported ones... I wont be, however, if its going to be detremental (spelling!) to performance.
Cheers, Mark
#2
Scooby Regular
iTrader: (13)
Unequal are still good for up to 400bhp I believe. And also, you're better off with polished and ported OEM ones, such as those sold off the shelf by harvey. PM/email him with your full engine spec, and he'll advise and also advise on the most appropriate ported uppipe for your spec, so as to retain max spool too...
Fitting tubular ones, if below c.400bhp, can be detrimental to bhp gains/spool-up and a could actually be a "backward step".
Fitting tubular ones, if below c.400bhp, can be detrimental to bhp gains/spool-up and a could actually be a "backward step".
Last edited by joz8968; 24 May 2010 at 07:57 PM.
Thread
Thread Starter
Forum
Replies
Last Post
jobegold@hotmail.co.uk
ScoobyNet General
43
24 September 2015 02:16 PM