defi water temp gauge
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: May 2006
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
defi water temp gauge
hi looking for some help as my water temp gauge is going all the way up to the maximum,checked wiring and one wire goes to top hose sensor,but there is another wire which isnt conected to anything was lying below top hose but is in the same cover as the one which goes to the top hose,temp gauge on dash is fine,any help would be great
#3
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: May 2006
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
defi
cheers for the reply,the one that is loose not conected has a round kind of spade conector(ring terminal),and the one that is conected to the top hose has a normal flat spade conection,dont know were the loose one goes
Last edited by komatsu; 21 May 2010 at 08:45 PM.
#6
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: May 2006
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
defi
hi i conected loose wire to an earth point,when i turn engine on the gauge goes all the way to maximum then settles down to around 100 130 on the gauge,dont know what else to do can they be caliberated?
Thread
Thread Starter
Forum
Replies
Last Post