Major Engine failure today.............
#1
Scooby Regular
Thread Starter
iTrader: (7)
Join Date: Mar 2009
Location: Down West.
Posts: 3,843
Likes: 0
Received 0 Likes
on
0 Posts
Major Engine failure today.............
Hi All - this follows on from my post on the Wales Section, as above really, Bearing went today pushing a rod through the block.
My slightlly modded JDM WRX with AVCS heads as standard (Not sure if all WRX's from JDM had these ?), died today...........the garage it got carried too, has an Sti engine there, what I'm wondering is, as my car is an AUTO - will it run with an Sti engine as opposed to the standard one, the owner say's it will be OK and the relavent bits for the Auto set up will transfer OK.....................car has been mapped by Bob R.
Any thought's
My slightlly modded JDM WRX with AVCS heads as standard (Not sure if all WRX's from JDM had these ?), died today...........the garage it got carried too, has an Sti engine there, what I'm wondering is, as my car is an AUTO - will it run with an Sti engine as opposed to the standard one, the owner say's it will be OK and the relavent bits for the Auto set up will transfer OK.....................car has been mapped by Bob R.
Any thought's
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM