Defi wiring classic
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jul 2008
Location: huddersfield
Posts: 431
Likes: 0
Received 0 Likes
on
0 Posts
Defi wiring classic
hi just wondering if anybody is able to tell me where is best for wiring up my defi controller for when the lights are on and also for permanent live only second click for ignition? Any help would be appreciated.
Cheers andy
Cheers andy
#2
Scooby Regular
iTrader: (2)
On mine, permanent live is taken from the rear of the hazard lights switch, and the lighting live I connected to the actual sidelights, which I found by removing the steering wheel shrouds, (2 screws underneath), and probing the wires coming from that side stalk with a circuit tester, until I found the correct one, then switching lights on and off to check it went on/off too.
My circuit tester was bought at a local carshop: it has a brass barrel with a sharp point on one end, used to pierce insulation, and a lead with a crocodile clip on the other end, used to connect to earth. Inside the barrel is a bulb that lights up if you find a live.
Cost me about £2, been worth it's weight in gold.
My circuit tester was bought at a local carshop: it has a brass barrel with a sharp point on one end, used to pierce insulation, and a lead with a crocodile clip on the other end, used to connect to earth. Inside the barrel is a bulb that lights up if you find a live.
Cost me about £2, been worth it's weight in gold.
Thread
Thread Starter
Forum
Replies
Last Post
serpico
ScoobyNet General
20
01 April 2019 07:47 AM