Check Engine Light
#1
Check Engine Light
Approx 2 weeks ago I connected the read memory connectors to see if it would flash up my abs fault code, it didn't help, since found its probably stored in the ABS ecu BUT since connecting the read connectors every so often I get the check engine light flashing when I turn on the ignition.
It flashes steady as if to say the ecu has been reset, not showing a code sequence to read. If I turn the ignition off and back on it goes away. It does this say 1 in very 20 times I turn the ignition on
If I plug the read connectors in it shows nothing
Any ideas??
It flashes steady as if to say the ecu has been reset, not showing a code sequence to read. If I turn the ignition off and back on it goes away. It does this say 1 in very 20 times I turn the ignition on
If I plug the read connectors in it shows nothing
Any ideas??
Thread
Thread Starter
Forum
Replies
Last Post
charlesr
General Technical
9
28 September 2015 09:16 AM
TylerD529
Lighting and Other Electrical
5
20 September 2015 12:10 PM