t.m.i.c swap
#1
Scooby Regular
Thread Starter
Join Date: Feb 2009
Location: bradford
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
t.m.i.c swap
hi guys will a top mount intercooler from a bugeye fit my classic i know i'll need a different dumpvalve and have found a techy article on fitting a hawkeye to a classic but doesnt mention a bugeye one , and will it make a difference
thanks in advance
thanks in advance
#2
yes it will fit but will need modifications to the bulkhead area and the clutch support bar bracket and also the intercooler itself will need altering,the dumpvalve will need blanking off as it may foul the idle control valve depending on what yr the classic is
#4
it is worth it,you have the slanted intercooler which isnt very good.
you will also need to buy a 2002-3 undertray for the scoop and modify that to suit so the air from the scoop goes direct into the intercooler as the original one for the slanted intercooler wont work/fit with the newer intercooler
you dont have to modify the bulkhead/clutch support bar bracket,but if you dont,it wont fit right and will rattle/vibrate and overall sound crap,some choose this option,i didnt and it fits sweet now
you will also need to buy a 2002-3 undertray for the scoop and modify that to suit so the air from the scoop goes direct into the intercooler as the original one for the slanted intercooler wont work/fit with the newer intercooler
you dont have to modify the bulkhead/clutch support bar bracket,but if you dont,it wont fit right and will rattle/vibrate and overall sound crap,some choose this option,i didnt and it fits sweet now
#6
no worries,wouldnt say words of wisdom,more words of trial n error ha ha
heres some pics to help
scoop undertray modified
and this is the part that needs altering,this isnt my car,didnt take a pic of mine on this part,but it needs to be narrowed to allow the Y Pipe to fit between it,so hammering both sides so instead of being like it is,more like a rectangle going downwards,also trim the lip of the bulkhead where the yellow wiring clips are,as it`ll catch here also
heres some pics to help
scoop undertray modified
and this is the part that needs altering,this isnt my car,didnt take a pic of mine on this part,but it needs to be narrowed to allow the Y Pipe to fit between it,so hammering both sides so instead of being like it is,more like a rectangle going downwards,also trim the lip of the bulkhead where the yellow wiring clips are,as it`ll catch here also
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM
M4RKG
General Technical
3
30 September 2015 07:51 PM