Hi Guys,

I have a 2002 JDM WRX - with a 3 pce exhaust system.

I've got a classic fitment decat downpipe - but my main concern is the position of the exhaust sensor as the hole for it (which is plugged at the moment) is at the bellmouth - the one on my exhaust (which has no Cat's in) is at the exhaust join by the gearbox.

Can I move the existing sensor to the new position on the bellmouth or fit a resistor if it won't fit the hole in the D/P and run with no sensor in the D/P and exhaust :w onder::won der:

 

leave it as it is as long as the bellmouth is sealed just leave the sensor in its orignal position thats what i did.

 

Thanks mate I'm sure the bellmouth will be fine, just the sensor position I was worried about - You had no issue with CEL's did you - did the newage sensor fit the diameter of the hole in the pipe OK, as said there is no hole in the pipe where the Newage one goes by the 1st exhaust Cat ? only up by the bellmouth