Water Injection pump broke with toluene - industrial chemist?
07 October 2009, 07:11 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2006
Location: South West
Posts: 1,568
Likes: 0
Received 0 Likes
on
0 Posts
Water Injection pump broke with toluene - industrial chemist?
Hey all,
Anyone using Aquamist kit with toluene and have problems with pump seals? I've just had mine replaced and Aquamist say seals bad due to reaction with chemical...
Any industrial chemists out there in scooby world that can advise if its better to use methanol in 50/50 mix for water injection (for seals) than toluene. Does same go for fuel pump seals at 10-20% in fuel tank mix of toluene compared to meth? Which is more corrosive to seals?
Anyone using Aquamist kit with toluene and have problems with pump seals? I've just had mine replaced and Aquamist say seals bad due to reaction with chemical...
Any industrial chemists out there in scooby world that can advise if its better to use methanol in 50/50 mix for water injection (for seals) than toluene. Does same go for fuel pump seals at 10-20% in fuel tank mix of toluene compared to meth? Which is more corrosive to seals?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
