Knock and Oxygen Sensor Fault
#1
Knock and Oxygen Sensor Fault
Help Please!
The check engine light has been coming on intermittently on MY99 Impreza which is pretty standard apart from Prodrive ECU and jasma system and backbox.
I have checked the fault codes and they read
No. 22 : Knocksensor.
and
No. 32 : Oxygen Sensor / AF sensor system
(think oxygen sensor = Lamba sensor?)
Should i be worried??
Could the two be connected or could one be an old fault.
Any advise how to remedy these, just replacing sensors, checking/cleaning connections etc?
Any idea of the cost of these sensors.
Its may also be worth mentioning that i have recently noticed a tapping noise, its not that loud at all and can only really be heard with the passanger window down when your are driving past walls at the side of the road etc, which bounces the sound back.
(A bit like the noise you get when a brick is stuck in the tyre.)
Your advice appreciated
Lee
The check engine light has been coming on intermittently on MY99 Impreza which is pretty standard apart from Prodrive ECU and jasma system and backbox.
I have checked the fault codes and they read
No. 22 : Knocksensor.
and
No. 32 : Oxygen Sensor / AF sensor system
(think oxygen sensor = Lamba sensor?)
Should i be worried??
Could the two be connected or could one be an old fault.
Any advise how to remedy these, just replacing sensors, checking/cleaning connections etc?
Any idea of the cost of these sensors.
Its may also be worth mentioning that i have recently noticed a tapping noise, its not that loud at all and can only really be heard with the passanger window down when your are driving past walls at the side of the road etc, which bounces the sound back.
(A bit like the noise you get when a brick is stuck in the tyre.)
Your advice appreciated
Lee
#4
Thanks for the reply,
Have reset ECU which seems to have cleared knock sensor fault.
But
Lamdba fault is still showing.
Suppose next job will be to change Lamdba and see if it clears.
Can you advise where to get a new one that will be a direct replacement and reliable rather than paying main dealer prices.
Have reset ECU which seems to have cleared knock sensor fault.
But
Lamdba fault is still showing.
Suppose next job will be to change Lamdba and see if it clears.
Can you advise where to get a new one that will be a direct replacement and reliable rather than paying main dealer prices.
#5
Scooby Regular
iTrader: (8)
Not sure which sensor your MY99 uses, my old '93 has the 3 wire zirconia type. The Bosch ones on here are the job
Just Lambda, Subaru lambda sensors, Bosch and NTK zirconia and titania sensors by post
Just Lambda, Subaru lambda sensors, Bosch and NTK zirconia and titania sensors by post
#6
Thanks again m8e,
Just need to confirm the subaru part number for my99 lamdba now to ensure i order the correct one.
Suppose i will have to get my existing one out to see, unless some one here can confirm Number
It is defo a three wire zirconia.
Just need to confirm the subaru part number for my99 lamdba now to ensure i order the correct one.
Suppose i will have to get my existing one out to see, unless some one here can confirm Number
It is defo a three wire zirconia.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM