ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   Knock and Oxygen Sensor Fault (https://www.scoobynet.com/general-technical-10/792946-knock-and-oxygen-sensor-fault.html)

jubba6 02 October 2009 07:15 PM

Knock and Oxygen Sensor Fault
 
Help Please!

The check engine light has been coming on intermittently on MY99 Impreza which is pretty standard apart from Prodrive ECU and jasma system and backbox.

I have checked the fault codes and they read

No. 22 : Knocksensor.
and
No. 32 : Oxygen Sensor / AF sensor system

(think oxygen sensor = Lamba sensor?)

Should i be worried??

Could the two be connected or could one be an old fault.

Any advise how to remedy these, just replacing sensors, checking/cleaning connections etc?

Any idea of the cost of these sensors.

Its may also be worth mentioning that i have recently noticed a tapping noise, its not that loud at all and can only really be heard with the passanger window down when your are driving past walls at the side of the road etc, which bounces the sound back.
(A bit like the noise you get when a brick is stuck in the tyre.)

Your advice appreciated
Lee

jubba6 03 October 2009 11:43 AM

btt

Glowplug 03 October 2009 04:48 PM

Firstly reset the ECU, this will clear any old/stored faults.

Lambda about £40-£50

Not sure on the KS:thumb:

jubba6 03 October 2009 05:11 PM

Thanks for the reply,

Have reset ECU which seems to have cleared knock sensor fault.
But
Lamdba fault is still showing.

Suppose next job will be to change Lamdba and see if it clears.

Can you advise where to get a new one that will be a direct replacement and reliable rather than paying main dealer prices.

Glowplug 03 October 2009 05:26 PM

Not sure which sensor your MY99 uses, my old '93 has the 3 wire zirconia type. The Bosch ones on here are the job:thumb:

Just Lambda, Subaru lambda sensors, Bosch and NTK zirconia and titania sensors by post

jubba6 03 October 2009 08:24 PM

Thanks again m8e,

Just need to confirm the subaru part number for my99 lamdba now to ensure i order the correct one.

Suppose i will have to get my existing one out to see, unless some one here can confirm Number

It is defo a three wire zirconia.

Glowplug 03 October 2009 08:39 PM


Originally Posted by jubba6 (Post 8977712)
It is defo a three wire zirconia.

Then you need the Bosch LS02:thumb:


All times are GMT +1. The time now is 06:45 PM.


© 2024 MH Sub I, LLC dba Internet Brands