enlarging the alignment holes on japspeed downpipe
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Mar 2008
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
enlarging the alignment holes on japspeed downpipe
ive got a japspeed downpipe & its so bloody tight to get on its unreal & just fowls the studs everytime its fitted or removed what would be the best way to make these slightly bigger?
#2
Scooby Regular
iTrader: (38)
Join Date: Sep 2009
Location: oxfordshire
Posts: 749
Likes: 0
Received 0 Likes
on
0 Posts
i had the exact same problem and only way i could get it on was to drill the holes out a couple of mm 's.being stainless steel though its not to easy to drill so take it steady and in small graduations
#4
Scooby Regular
iTrader: (38)
Join Date: Sep 2009
Location: oxfordshire
Posts: 749
Likes: 0
Received 0 Likes
on
0 Posts
dont no why they sell them with so small holes i sent my first one back cause i could nt get it on.Then was horrified to find the second was the same and just could nt be bothred to send it back.cant quite remember exactly but i think i drilled holes out to either 12 or 13 mm and it fitted like a glove
Thread
Thread Starter
Forum
Replies
Last Post
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM