Hyperflow CAI
07 April 2009, 08:51 AM
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Location: Also known as The Gimp
Posts: 3,662
Likes: 0
Received 0 Likes
on
0 Posts
Hyperflow CAI
Just fitted my CAI to my car along with MD321T and LP up-pipe and headers.
Just a quick question reagrds the CAI itself. I've been using my friends Scoob over the course of the weekend and that also has a CAI (make not known) and makes the chattering noise on his TD04.
I took my car our for a test run yesterday prior to todays mapping (was not giving it beans) but could not get the noise that my friends car makes?
Both are running TMIC not FMIC. But my friends car runs a Turbosmart dual port (hard setting) and I run a Forge Re-circ with red spring and shim. I know the TD04 spools a lot quicker etc and I wasn't running it on boost but surely I should still get the same noise?
It's most likely a pointless question but feel I needed to ask.
Steve
Just a quick question reagrds the CAI itself. I've been using my friends Scoob over the course of the weekend and that also has a CAI (make not known) and makes the chattering noise on his TD04.
I took my car our for a test run yesterday prior to todays mapping (was not giving it beans) but could not get the noise that my friends car makes?
Both are running TMIC not FMIC. But my friends car runs a Turbosmart dual port (hard setting) and I run a Forge Re-circ with red spring and shim. I know the TD04 spools a lot quicker etc and I wasn't running it on boost but surely I should still get the same noise?
It's most likely a pointless question but feel I needed to ask.
Steve
Thread
Thread Starter
Forum
Replies
Last Post
BlueBlobZA
Member's Gallery
30
25 July 2016 09:14 AM
fatboy_coach
General Technical
15
18 June 2016 03:48 PM